Model R4040S

Features

  • 12 Amp Motor - heavy duty motor powers through natural or manmade tile and pavers
  • Oversized Cut Capacity - 24 inch rip, 18 inch diagonal, 2-3/4 inch deep, can cut up to 5 inch wide extra-long backsplash or threshold material
  • Removable Rear Water Tray - captures over spray and water from larger tiles to keep work area clean
  • Aluminum Miter Guide - precision straight and miter cuts from 0° to 45° left and right
  • Heavy Duty Cast Aluminum Arm - prevents flexing while keeping the cutting wheel aligned
  • Folding Stand - tool-less height adjustment and scratch resistant feet to help protect flooring

Specifications

Input 120 V AC, 12 Amps
No Load Speed 5,000 r/min. (RPM)
Cutting Wheel Diameter 8 in.
Rip Capacity 24 in.
Diagonal Capacity 18 in.
Backsplash Capacity 5 in.
Max Depth Of Cut 2-3/4 in.
Weight 49 lbs.

Request Information

Includes

R4040 Tile Saw, Stand, Hex Wrench, 8" Diamond Cutting Wheel, Cutting Wheel Wrench, Rear Splash Guard, Folding Stand, Filter, Side Splash Guard, Miter Guide, Submersible Pump, Water Tray, Rear Water Tray, and Operator’s Manuals
Rated 4 out of 5 by 1 reviewer.
Rated 4 out of 5 by Pretty good tile saw, except... This tile saw is rated to be able to rip 24" long tile. While the distance from the backstop of the sliding table to the front edge of the blade is indeed more than 24", the table itself is only 13.5", leaving at least ten inches of tile hanging out in space when you make a rip cut. This is fine for ripping a square tile since there is alot of material to support that overhang. Unfortunately, ripping a very expensive 24" bullnose which is barely 4" wide to begin with seems no small risk of snapping the tile in half. I thought I'd use a piece of Hardibacker underneath the tile for support, but the backstop is only about 3/8" high so that the back edge of the bullnose piece will not be against the backstop. There should have been a removable piece of the backstop about five inches wide so that one could begin the cut with the skinny tile hanging out the back but against the angle stop until the cut is half made, then reinstall (with two Allen screws) the backstop and complete the cut that way. November 2, 2013
1-1 of 1
1 Question | 1 Answer

Product Q&A

 
 
Back >>
 
 
5 months, 1 week ago
Customer avatar
by
az
Read all my Q&A
 
Please wait while more information about floorlou is loaded.
Additional information about floorlou could not be loaded.
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers

Answer: 
At this time, there is no information available concerning a possible table extension accessory for the RIDGID R4040S model tile saw.

Thank you
RIDGID
5 months, 1 week ago
Customer avatar
by
Read all my Q&A
 
Please wait while more information about RIDGID is loaded.
Additional information about RIDGID could not be loaded.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0
1 of 1
1 of 1