The RIDGID Model 258 Power Pipe Cutter cuts 2 1⁄2" (65 mm) to 8" (200 mm) schedule 10*/40 steel pipe, galvanized pipe, rigid conduit, etc. at the job site or in the shop. Powered by the RIDGID No. 700 Power Drive, the 258 is a displacement cutter that provides square cuts. The operator controls the feeding rate by pumping the hydraulic foot pump throughout the operation. A square cut with minimal burr on either 21 ft (6m) or nipple lengths of pipe is achieved quickly** without abrasive dust, sparks, or open flame. Also, the RIDGID Pipe Roller for beveling can be used to rotate the pipe while second operator uses a grinder to bevel the pipe.

Features

  • Square cut 21ft (6m) or nipple lengths of pipe without effort.
  • Easily cuts by displacing instead of removing pipe material.
  • No abrasive dust, dangerous sparks, or open flame.
  • Quickly cuts steel pipe with minimal burr.
  • Great for cutting pipe for groove joining.
  • Heavy-duty design is perfect for field or shop use.
  • Adaptable for beveling.

Specifications

Cutting Capacity 2 1⁄2" (65 mm) to 8" (200 mm) schedule 10*/40 steel pipe
Powered by a model 700 Power Drive (not included)
Power Drive RPM 26-30 (no load)
Weight 105 lbs. (48 kg)

Ordering Information

 
Catalog Number Model No. Description Weight
lb. kg
50767 258  Pipe Cutter  105  48 

Accessories

Catalog Number Model No. Description Weight
lb. kg
66687   8 1/2" H-D Cutter Wheel Assembly (includes HD Cutter Wheel, hub w/pins, cover plate)  13 
50812 E-258  8 1/2" H-D Cutter Wheel only 
58222 E258-T  8 1/2" Thin Wall Cutter Wheel Only (PVC and Steel) 
54397   Transport Cart  24  11 
60002 258PS  Ball transfer Pipe Support 2 1/2" (65mm) to 12" (300mm)  21  10 
61757   Pipe Roller for Beveling (for Model 258 only)  13 

Request Information

1 Question | 1 Answer

Product Q&A

 
 
Back >>
 
 
4 months, 2 weeks ago
Customer avatar
by
Read all my Q&A
 
Please wait while more information about clinton is loaded.
Additional information about clinton could not be loaded.
0points
0out of 0found this question helpful.
Was this helpful?helpful0unhelpful0

Answers

Answer: 
The pivot arm should be set at the 2” to 4” setting. When inserting the pipe underneath the cutter wheel, lift up on the front end of the pivot arm to create enough room for the 5” pipe.
If you have any further questions please contact our Technical Support Department at 888-743-4333.

Thank you
RIDGID
4 months, 2 weeks ago
Customer avatar
by
Read all my Q&A
 
Please wait while more information about RIDGID is loaded.
Additional information about RIDGID could not be loaded.
0points
0out of 0found this answer helpful.
Was this helpful?helpful0unhelpful0
1 of 1
1 of 1